Windows xp , dualboot Ubuntu 10.10
Onder windows xp werkt de draadloze netwerkkaart.
Onder Ubuntu werkt deze niet.
Vermoedelijk kan de hardwareknop niet bediend worden, de knop die op het toetsenbord aanwezig is om de wireless in te schakelen?
Lspci en nm-tool:lspci via terminal:
my@my-Pavilion-zv5000-PJ888EA-UUG:~$ lspci
00:00.0 Host bridge: ATI Technologies Inc Radeon 9100 IGP Host Bridge (rev 02)
00:01.0 PCI bridge: ATI Technologies Inc Radeon 9100 IGP AGP Bridge
00:13.0 USB Controller: ATI Technologies Inc OHCI USB Controller #1 (rev 01)
00:13.1 USB Controller: ATI Technologies Inc OHCI USB Controller #2 (rev 01)
00:14.0 SMBus: ATI Technologies Inc SMBus (rev 16)
00:14.1 IDE interface: ATI Technologies Inc Dual Channel Bus Master PCI IDE Controller
00:14.3 ISA bridge: ATI Technologies Inc Device 434c
00:14.4 PCI bridge: ATI Technologies Inc IXP200 3COM 3C920B Ethernet Controller
00:14.5 Multimedia audio controller: ATI Technologies Inc IXP150 AC'97 Audio Controller
00:14.6 Modem: ATI Technologies Inc IXP AC'97 Modem (rev 01)
01:05.0 VGA compatible controller: ATI Technologies Inc RS300M AGP [Radeon Mobility 9100IGP]
02:00.0 FireWire (IEEE 1394): Texas Instruments TSB43AB21 IEEE-1394a-2000 Controller (PHY/Link)
02:02.0 Network controller: Broadcom Corporation BCM4306 802.11b/g Wireless LAN Controller (rev 03)
02:03.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
02:04.0 CardBus bridge: Texas Instruments PCI1620 PC Card Controller (rev 01)
02:04.1 CardBus bridge: Texas Instruments PCI1620 PC Card Controller (rev 01)
02:04.2 System peripheral: Texas Instruments PCI1620 Firmware Loading Function (rev 01)
02:07.0 USB Controller: NEC Corporation USB (rev 43)
02:07.1 USB Controller: NEC Corporation USB (rev 43)
02:07.2 USB Controller: NEC Corporation USB 2.0 (rev 04)
zoro@zoro-Pavilion-zv5000-PJ888EA-UUG:~$
---------------------------------------------------------------------------------------------------------
nm-tool via terminal:
my@my-Pavilion-zv5000-PJ888EA-UUG:~$ nm-tool
NetworkManager Tool
State: disconnected
- Device: wlan0 ----------------------------------------------------------------
Type: 802.11 WiFi
Driver: b43
State: unavailable
Default: no
HW Address: 00:90:4B:9A:1D:73
Capabilities:
Wireless Properties
WEP Encryption: yes
WPA Encryption: yes
WPA2 Encryption: yes
Wireless Access Points
- Device: eth0 -----------------------------------------------------------------
Type: Wired
Driver: 8139too
State: unavailable ---> (MET BEKABELING WERKT DEZE GOED!)
Default: no
HW Address: 00:0F:B0:0F:62:78
Capabilities:
Carrier Detect: yes
Speed: 10 Mb/s
Wired Properties
Carrier: off
-------------------------------------------------------------------------------------------------------------------------------------
Iemand een idee hoe ik dat ding ingeschakeld krijg?
