ik denk dat niet alles op mijn scherm geraakt,
maar hier is de output van -a
ben wat aan het rondlezen over smart, want ik snap er nog niet zo veel van.
alvast bedankt!
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x80) Offline data collection activity
was never started.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 242) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
No General Purpose Logging support.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 54) minutes.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
3 Spin_Up_Time 0x0027 252 252 063 Pre-fail Always - 1412
4 Start_Stop_Count 0x0032 253 253 000 Old_age Always - 7
5 Reallocated_Sector_Ct 0x0033 229 229 063 Pre-fail Always - 244
6 Read_Channel_Margin 0x0001 253 253 100 Pre-fail Offline - 0
7 Seek_Error_Rate 0x000a 253 252 000 Old_age Always - 0
8 Seek_Time_Performance 0x0027 252 252 187 Pre-fail Always - 58302
9 Power_On_Minutes 0x0032 249 249 000 Old_age Always - 477h+10m
10 Spin_Retry_Count 0x002b 252 252 157 Pre-fail Always - 0
11 Calibration_Retry_Count 0x002b 252 252 223 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 251 251 000 Old_age Always - 790
192 Power-Off_Retract_Count 0x0032 253 253 000 Old_age Always - 0
193 Load_Cycle_Count 0x0032 253 253 000 Old_age Always - 0
194 Temperature_Celsius 0x0032 253 253 000 Old_age Always - 35
195 Hardware_ECC_Recovered 0x000a 253 252 000 Old_age Always - 14233
196 Reallocated_Event_Count 0x0008 253 253 000 Old_age Offline - 0
197 Current_Pending_Sector 0x0008 243 243 000 Old_age Offline - 107
198 Offline_Uncorrectable 0x0008 253 253 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x0008 199 199 000 Old_age Offline - 0
200 Multi_Zone_Error_Rate 0x000a 253 252 000 Old_age Always - 0
201 Soft_Read_Error_Rate 0x000a 253 252 000 Old_age Always - 44
202 TA_Increase_Count 0x000a 253 252 000 Old_age Always - 0
203 Run_Out_Cancel 0x000b 253 252 180 Pre-fail Always - 7
204 Shock_Count_Write_Opern 0x000a 253 252 000 Old_age Always - 0
205 Shock_Rate_Write_Opern 0x000a 253 252 000 Old_age Always - 0
207 Spin_High_Current 0x002a 252 252 000 Old_age Always - 0
208 Spin_Buzz 0x002a 252 252 000 Old_age Always - 0
209 Offline_Seek_Performnce 0x0024 195 195 000 Old_age Offline - 0
99 Unknown_Attribute 0x0004 253 253 000 Old_age Offline - 0
100 Unknown_Attribute 0x0004 253 253 000 Old_age Offline - 0
101 Unknown_Attribute 0x0004 253 253 000 Old_age Offline - 0
SMART Error Log Version: 1
Warning: ATA error count 2227 inconsistent with error log pointer 5
ATA Error Count: 2227 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 2227 occurred at disk power-on lifetime: 1444 hours (60 days + 4 hours)
When the command that caused the error occurred, the device was in an unknown state.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 09 76 00 00 f0 Error: UNC 9 sectors at LBA = 0x00000076 = 118
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 09 76 00 00 f0 08 3d+15:36:58.448 READ DMA
c8 00 0a 75 00 00 f0 08 3d+15:36:57.280 READ DMA
c8 00 0b 74 00 00 f0 08 3d+15:36:56.112 READ DMA
c8 00 0c 73 00 00 f0 08 3d+15:36:54.944 READ DMA
c8 00 0d 72 00 00 f0 08 3d+15:36:53.760 READ DMA
Error 2226 occurred at disk power-on lifetime: 1444 hours (60 days + 4 hours)
When the command that caused the error occurred, the device was in an unknown state.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 0a 75 00 00 f0 Error: UNC 10 sectors at LBA = 0x00000075 = 117
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 0a 75 00 00 f0 08 3d+15:36:57.280 READ DMA
c8 00 0b 74 00 00 f0 08 3d+15:36:56.112 READ DMA
c8 00 0c 73 00 00 f0 08 3d+15:36:54.944 READ DMA
c8 00 0d 72 00 00 f0 08 3d+15:36:53.760 READ DMA
c8 00 0e 71 00 00 f0 08 3d+15:36:52.608 READ DMA
Error 2225 occurred at disk power-on lifetime: 1444 hours (60 days + 4 hours)
When the command that caused the error occurred, the device was in an unknown state.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 0b 74 00 00 f0 Error: UNC 11 sectors at LBA = 0x00000074 = 116
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 0b 74 00 00 f0 08 3d+15:36:56.112 READ DMA
c8 00 0c 73 00 00 f0 08 3d+15:36:54.944 READ DMA
c8 00 0d 72 00 00 f0 08 3d+15:36:53.760 READ DMA
c8 00 0e 71 00 00 f0 08 3d+15:36:52.608 READ DMA
c8 00 0f 70 00 00 f0 08 3d+15:36:51.424 READ DMA
Error 2224 occurred at disk power-on lifetime: 1444 hours (60 days + 4 hours)
When the command that caused the error occurred, the device was in an unknown state.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 0c 73 00 00 f0 Error: UNC 12 sectors at LBA = 0x00000073 = 115
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 0c 73 00 00 f0 08 3d+15:36:54.944 READ DMA
c8 00 0d 72 00 00 f0 08 3d+15:36:53.760 READ DMA
c8 00 0e 71 00 00 f0 08 3d+15:36:52.608 READ DMA
c8 00 0f 70 00 00 f0 08 3d+15:36:51.424 READ DMA
c8 00 10 6f 00 00 f0 08 3d+15:36:50.256 READ DMA
Error 2223 occurred at disk power-on lifetime: 1444 hours (60 days + 4 hours)
When the command that caused the error occurred, the device was in an unknown state.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 0d 72 00 00 f0 Error: UNC 13 sectors at LBA = 0x00000072 = 114
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 0d 72 00 00 f0 08 3d+15:36:53.760 READ DMA
c8 00 0e 71 00 00 f0 08 3d+15:36:52.608 READ DMA
c8 00 0f 70 00 00 f0 08 3d+15:36:51.424 READ DMA
c8 00 10 6f 00 00 f0 08 3d+15:36:50.256 READ DMA
c8 00 11 6e 00 00 f0 08 3d+15:36:49.088 READ DMA
SMART Self-test log structure revision number 1
No self-tests have been logged. [To run self-tests, use: smartctl -t]
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
michiel@server:~$