Indien je je echte handleiding download van je moederbord, dan vind je daar uitleg over je hardware, en daar zijn je ide aansluitingen genummerd 1, 2, 3, 4, maar als goed is staat op de handleiding van je moederbord 0, 1, 2 ,3. Dus 0 is ide 1, daar de harde schijf op zetten.
http://ubuntuforums.org/showthread.php?t=1506552http://ubuntuforums.org/showthread.php?t=1311512Harde schijf op een andere kontroller zetten indien je moederbord er meer heeft.
ATA/IDE Mode > Native and Legacy (Native is enabled), kijk of je dit hebt in de bios, probeer eens alle 2.
Also, you can try booting the laptop with the extra kernel option "noapic". Here are more detailed instructions on how to do that. how to boot with the "noapic" option? [Archive] - Ubuntu Forums
http://ubuntuforums.org/archive/index.php/t-148761.htmlACPI in je bios uitzetten.
I had a issue when installing where the partioner just kept searching for installed hard drives. Not sure if its the same issue here.
If it is, unplug any usb drives you have pluged in and try. Mine ended up being a card reader on my printer that it was getting stuck on. Dus alle usb apparaten verwijderen. En stel in de bios de boot volgorde opnieuw in.
It was a hard drive issue, the drives chose not to accept Master/slave PIN configuration, so i changed to Cable select.