Vanmiddag leek de ventilator van mijn pc bijna even hard te brullen als die in de woonkamer.
Vandaar dan ook dat ik maar even wat metertjes heb geïnstalleerd; de systeembelastingmeter en het sensorsapplet.
Bij het installeren van het sensors-applet krijg ik de volgende melding en ik weet niet wat ik ermee moet:
Now follows a summary of the probes I have just done.
Just press ENTER to continue:
Driver `k10temp':
* Chip `AMD Family 10h thermal sensors' (confidence: 9)
Driver `f71882fg':
* ISA bus, address 0xa00
Chip `Fintek F71862FG Super IO Sensors' (confidence: 9)
Warning: the required module k10temp is not currently installed
on your system. If it is built into the kernel then it's OK.
Otherwise, check
http://www.lm-sensors.org/wiki/Devices for
driver availability.
To load everything that is needed, add this to /etc/modules:
#----cut here----
# Chip drivers
f71882fg
#----cut here----
If you have some drivers built into your kernel, the list above will
contain too many modules. Skip the appropriate ones!
Do you want to add these lines automatically to /etc/modules? (yes/NO)y
Successful!
Monitoring programs won't work until the needed modules are
loaded. You may want to run '/etc/init.d/module-init-tools start'
to load them.
Unloading i2c-dev... OK
