Nieuws:

Welkom, Gast. Alsjeblieft inloggen of registreren.
Heb je de activerings-mail niet ontvangen?

Auteur Topic: Draadloos internet werkt niet met Broadcom Corp BCM4318 [Airforce One 54g] ...  (gelezen 2099 keer)

Poesj

  • Gast
Goedemorgen,

Ik heb blijkbaar een probleem om draadloos internet te activeren op ubuntu. Heb al vanalles gedaan maar voorlopig werkt er niets. Ps ik heb de windows drivers niet en heb uitsluitend ubuntu op pc staan.


Vriendelijke groeten

Offline Johan van Dijk

  • Administrator
    • johanvandijk
Zorg dat je tijdelijk even verbinding maakt via een kabel.
Daarna kan je via systeem>beheer>hardware drivers de goede drivers installeren.

Poesj

  • Gast
reeds gedaan maar werkt nog steeds niet

Offline Johan van Dijk

  • Administrator
    • johanvandijk
Heb je toevallig een laptop met een aparte schakelaar/toets om de wireless aan en uit te zetten?

Poesj

  • Gast
ja maar de wireless staat aan volgens de verlichte knop

Offline Johan van Dijk

  • Administrator
    • johanvandijk
Wat zie je als je in een terminalvenster het volgende commando uitvoert?
iwlist scan

Poesj

  • Gast
lo        Interface doesn't support scanning.

eth0      Interface doesn't support scanning.

wmaster0  Interface doesn't support scanning.

wlan0     No scan results

Offline Johan van Dijk

  • Administrator
    • johanvandijk
Wat zegt het commando sudo iwlist scan ?
(Als je je wachtwoord invoert zie je geen sterretjes. Gewoon invoeren en op enter drukken)

Poesj

  • Gast
Zelfde als daarnet

Offline Johan van Dijk

  • Administrator
    • johanvandijk
Wat is het merk en type van je laptop?

En kan je ook het resultaat van het volgende commando hier neerzetten?
dmesg | grep b43

Poesj

  • Gast
Merk HP Pavilion zd8000
Output terminal

[   28.807891] b43-phy0: Broadcom 4318 WLAN found
[   28.849128] b43-phy0 debug: Found PHY: Analog 3, Type 2, Revision 7
[   28.849155] b43-phy0 debug: Found Radio: Manuf 0x17F, Version 0x2050, Revision 8
[   29.718857] input: b43-phy0 as /devices/virtual/input/input9
[   30.031299] b43-phy0 debug: Loading firmware version 351.126 (2006-07-29 05:54:02)
[   30.902678] b43-phy0 debug: Chip initialized
[   30.902856] b43-phy0 debug: 32-bit DMA initialized
[   30.920338] Registered led device: b43-phy0:radio
[   30.920377] b43-phy0 debug: Wireless interface started
[   30.920389] b43-phy0: Radio hardware status changed to DISABLED
[   30.920429] b43-phy0 debug: Adding Interface type 2
[   30.975953] b43-phy0 debug: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
[  114.599773] b43-phy0 debug: Disabling hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
[  114.599784] b43-phy0 debug: Removing Interface type 2
[  114.659917] b43-phy0 debug: Wireless interface stopped
[  114.660017] b43-phy0 debug: DMA-32 0x0200 (RX) max used slots: 0/64
[  114.660089] b43-phy0 debug: DMA-32 0x02A0 (TX) max used slots: 0/128
[  114.667783] b43-phy0 debug: DMA-32 0x0280 (TX) max used slots: 0/128
[  114.675718] b43-phy0 debug: DMA-32 0x0260 (TX) max used slots: 0/128
[  114.683711] b43-phy0 debug: DMA-32 0x0240 (TX) max used slots: 0/128
[  114.691717] b43-phy0 debug: DMA-32 0x0220 (TX) max used slots: 2/128
[  114.696855] b43-phy0 debug: DMA-32 0x0200 (TX) max used slots: 0/128
[  114.775927] input: b43-phy0 as /devices/virtual/input/input10
[  114.958336] b43-phy0 debug: Loading firmware version 351.126 (2006-07-29 05:54:02)
[  115.736609] b43-phy0 debug: Chip initialized
[  115.736827] b43-phy0 debug: 32-bit DMA initialized
[  115.755506] Registered led device: b43-phy0:radio
[  115.755545] b43-phy0 debug: Wireless interface started
[  115.804088] b43-phy0 debug: Adding Interface type 2
[  115.804136] b43-phy0: Radio hardware status changed to DISABLED
[  116.150805] b43-phy0 debug: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
[  174.633886] b43-phy0 debug: Disabling hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
[  174.633910] b43-phy0 debug: Removing Interface type 2
[  174.713504] b43-phy0 debug: Wireless interface stopped
[  174.713626] b43-phy0 debug: DMA-32 0x0200 (RX) max used slots: 0/64
[  174.713693] b43-phy0 debug: DMA-32 0x02A0 (TX) max used slots: 0/128
[  174.721276] b43-phy0 debug: DMA-32 0x0280 (TX) max used slots: 0/128
[  174.729265] b43-phy0 debug: DMA-32 0x0260 (TX) max used slots: 0/128
[  174.737265] b43-phy0 debug: DMA-32 0x0240 (TX) max used slots: 0/128
[  174.745255] b43-phy0 debug: DMA-32 0x0220 (TX) max used slots: 2/128
[  174.753255] b43-phy0 debug: DMA-32 0x0200 (TX) max used slots: 0/128
[  174.917648] input: b43-phy0 as /devices/virtual/input/input11
[  175.068117] b43-phy0 debug: Loading firmware version 351.126 (2006-07-29 05:54:02)
[  175.862129] b43-phy0 debug: Chip initialized
[  175.862350] b43-phy0 debug: 32-bit DMA initialized
[  175.880993] Registered led device: b43-phy0:radio
[  175.881033] b43-phy0 debug: Wireless interface started
[  175.947243] b43-phy0: Radio hardware status changed to DISABLED
[  175.977611] b43-phy0 debug: Adding Interface type 2
[ 3594.100604] b43-phy0 debug: Removing Interface type 2
[ 3594.160716] b43-phy0 debug: Wireless interface stopped
[ 3594.160802] b43-phy0 debug: DMA-32 0x0200 (RX) max used slots: 0/64
[ 3594.160851] b43-phy0 debug: DMA-32 0x02A0 (TX) max used slots: 0/128
[ 3594.168563] b43-phy0 debug: DMA-32 0x0280 (TX) max used slots: 0/128
[ 3594.174684] b43-phy0 debug: DMA-32 0x0260 (TX) max used slots: 0/128
[ 3594.180556] b43-phy0 debug: DMA-32 0x0240 (TX) max used slots: 0/128
[ 3594.188553] b43-phy0 debug: DMA-32 0x0220 (TX) max used slots: 2/128
[ 3594.196548] b43-phy0 debug: DMA-32 0x0200 (TX) max used slots: 0/128
[ 3594.867112] input: b43-phy0 as /devices/virtual/input/input12
[ 3595.019023] b43-phy0 debug: Loading firmware version 351.126 (2006-07-29 05:54:02)
[ 3595.833147] b43-phy0 debug: Chip initialized
[ 3595.833670] b43-phy0 debug: 32-bit DMA initialized
[ 3595.852229] Registered led device: b43-phy0:radio
[ 3595.852270] b43-phy0 debug: Wireless interface started
[ 3595.899614] b43-phy0 debug: Adding Interface type 2
[ 3595.899643] b43-phy0: Radio hardware status changed to DISABLED
[ 3596.576211] b43-phy0: Radio turned on by software
[ 3596.576221] b43-phy0: The hardware RF-kill button still turns the radio physically off. Press the button to turn it on.

Poesj

  • Gast
[ 5797.974821] b43-phy0: Radio hardware status changed to ENABLED

Poesj

  • Gast
Beste,

Wireless staat nu tussen lijst en verbinding blijkt te werken... geen idee hoe dat komt?

Offline Johan van Dijk

  • Administrator
    • johanvandijk
Vreemd hoor, maar mooi dat het weer werkt :)

Als ik kijk naar bijvoorbeeld deze regels:
[ 3595.899643] b43-phy0: Radio hardware status changed to DISABLED
en
[ 5797.974821] b43-phy0: Radio hardware status changed to ENABLED
Dan denk ik dat het toch met de schakelaar voor de wireless te maken heeft.

Poesj

  • Gast
Ok bedankt, tegen de tijd dat ik wat beter overweg kan met linux zal ik wel eens proberen uit te zoeken waar het mis liep maar nu eerst de basis onder de knie krijgen.

Alvast bedankt voor de hulp