@ Autostatic
Resultaten
paul@paul-laptop:~$ [b]sudo hdparm -iI /dev/sda[/b]
/dev/sda:
Model=ST980811AS , FwRev=3.ALC , SerialNo= 5LY2RLR3
Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs RotSpdTol>.5% }
RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=4
BuffType=unknown, BuffSize=8192kB, MaxMultSect=16, MultSect=?16?
CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=156301488
IORDY=on/off, tPIO={min:240,w/IORDY:120}, tDMA={min:120,rec:120}
PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 mdma2
UDMA modes: udma0 udma1 udma2 udma3 udma4 *udma5 udma6
AdvancedPM=yes: unknown setting WriteCache=enabled
Drive conforms to: Unspecified: ATA/ATAPI-1,2,3,4,5,6,7
* signifies the current active mode
ATA device, with non-removable media
Model Number: ST980811AS
Serial Number: 5LY2RLR3
Firmware Revision: 3.ALC
Standards:
Supported: 7 6 5 4
Likely used: 8
Configuration:
Logical max current
cylinders 16383 16383
heads 16 16
sectors/track 63 63
--
CHS current addressable sectors: 16514064
LBA user addressable sectors: 156301488
LBA48 user addressable sectors: 156301488
device size with M = 1024*1024: 76319 MBytes
device size with M = 1000*1000: 80026 MBytes (80 GB)
Capabilities:
LBA, IORDY(can be disabled)
Queue depth: 32
Standby timer values: spec'd by Standard, no device specific minimum
R/W multiple sector transfer: Max = 16 Current = 16
Advanced power management level: 254
Recommended acoustic management value: 254, current value: 0
DMA: mdma0 mdma1 mdma2 udma0 udma1 udma2 udma3 udma4 *udma5 udma6
Cycle time: min=120ns recommended=120ns
PIO: pio0 pio1 pio2 pio3 pio4
Cycle time: no flow control=240ns IORDY flow control=120ns
Commands/features:
Enabled Supported:
* SMART feature set
Security Mode feature set
* Power Management feature set
* Write cache
* Look-ahead
* Host Protected Area feature set
* WRITE_BUFFER command
* READ_BUFFER command
* DOWNLOAD_MICROCODE
* Advanced Power Management feature set
SET_MAX security extension
* 48-bit Address feature set
* Device Configuration Overlay feature set
* Mandatory FLUSH_CACHE
* FLUSH_CACHE_EXT
* SMART error logging
* SMART self-test
* IDLE_IMMEDIATE with UNLOAD
* SATA-I signaling speed (1.5Gb/s)
* Native Command Queueing (NCQ)
* Phy event counters
Device-initiated interface power management
* Software settings preservation
* SMART Command Transport (SCT) feature set
Security:
Master password revision code = 65534
supported
not enabled
not locked
frozen
not expired: security count
not supported: enhanced erase
Checksum: correct
paul@paul-laptop:~$[b] lspci[/b]
00:00.0 Host bridge: ATI Technologies Inc Device 5a31 (rev 01)
00:01.0 PCI bridge: ATI Technologies Inc RS480 PCI Bridge
00:12.0 IDE interface: ATI Technologies Inc IXP SB400 Serial ATA Controller (rev 80)
00:13.0 USB Controller: ATI Technologies Inc IXP SB400 USB Host Controller (rev 80)
00:13.1 USB Controller: ATI Technologies Inc IXP SB400 USB Host Controller (rev 80)
00:13.2 USB Controller: ATI Technologies Inc IXP SB400 USB2 Host Controller (rev 80)
00:14.0 SMBus: ATI Technologies Inc IXP SB400 SMBus Controller (rev 82)
00:14.1 IDE interface: ATI Technologies Inc IXP SB400 IDE Controller (rev 80)
00:14.2 Audio device: ATI Technologies Inc IXP SB4x0 High Definition Audio Controller (rev 01)
00:14.3 ISA bridge: ATI Technologies Inc IXP SB400 PCI-ISA Bridge (rev 80)
00:14.4 PCI bridge: ATI Technologies Inc IXP SB400 PCI-PCI Bridge (rev 80)
01:05.0 VGA compatible controller: ATI Technologies Inc RC410 [Radeon Xpress 200M]
09:02.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
09:04.0 Network controller: RaLink RT2561/RT61 rev B 802.11g
paul@paul-laptop:~$
paul@paul-laptop:~$ [b]sudo fdisk -l[/b]
Schijf /dev/sda: 80.0 GB, 80026361856 bytes
255 koppen, 63 sectoren/spoor, 9729 cilinders
Eenheid = cilinders van 16065 * 512 = 8225280 bytes
Schijf-ID: 0x0acabf2a
Apparaat Opstart Begin Einde Blokken ID Systeem
/dev/sda1 8037 9729 13599022+ 5 Uitgebreid
/dev/sda2 * 1045 4242 25679902+ 7 HPFS/NTFS
/dev/sda3 4243 8036 30475305 7 HPFS/NTFS
/dev/sda4 1 1044 8385898+ 7 HPFS/NTFS
/dev/sda5 8037 9652 12980488+ 83 Linux
/dev/sda6 9653 9729 618471 82 Linux wisselgeheugen
Partitietabel-items liggen niet in schijfvolgorde.
Schijf /dev/sdb: 8065 MB, 8065646080 bytes
8 koppen, 32 sectoren/spoor, 61535 cilinders
Eenheid = cilinders van 256 * 512 = 131072 bytes
Schijf-ID: 0x00000000
Apparaat Opstart Begin Einde Blokken ID Systeem
/dev/sdb1 * 1 61536 7876591+ b W95 FAT32
paul@paul-laptop:~$
edit moderator: lange lijst in code gezet.