Build essentials zijn al reeds geinstalleerd en ik kan geen driver activeren behalve die voor de grafische kaart.
Ik heb geprobeerd de driver te installeren via de readme :
===============================================================================
Installation
===============================================================================
<<Method 1>>
Runing the scripts accomplish all operations including building up modules
from the source code, installing driver to the kernel and starting up the nic.
1. Build up the drivers from the source code
make
2. Install the driver to the kernel
make install
reboot
3. bring up wlan if nic is not brought up by GUI, such as NetworkManager
ifconfig wlan0 up
Note: use ifconfig to check whether wlan0 is brought up and use iwconfig to check your wlan interface name,
since it may change wlan0 to wlan1,etc.
<<Method 2>>
Or only load the driver module to kernel and start up nic.
1. Build up the drivers from the source code
make
2. Copy firmware to /lib/firmware/ or /lib/firmware/(KERNEL_VERSION)/
cp -rf firmware/RTL8192SU /lib/firmware
or
cp -rf firmware/RTL8192SU /lib/firmware/(KERNEL_VERSION)
Note: This depends on whether (KERNEL_VERSION) subdirectory exists under /lib/firmware
3. Load driver module to kernel and start up nic.
./wlan0up
Note: when "insmod: error inserting 'xxxx.ko': -1 File exists" comes out
after run ./wlan0up, please run ./wlan0down first, then it should
be ok..
Note: If you see the message of "unkown symbol" during ./wlan0up, it
is suggested to build driver by <<Method 1>>.
Aangezien de build al verkeerd gaat (zie de errors in mijn vorige commentaar) dan kan het ook niet anders dat het geheel niet goed gaat werken, en ja ik heb beide methodes geprobeerd en als ik ./wlan0down en dan ./wlan0up uitvoer dan krijg ik een aantal AP's te zien welke ik geen van allen kan benutten.