Hier ben ik dan weer met de informatie waar gevraagd om is:
Eerst maar de tekst die tevoorschijn komt bij de opdracht: ifconfig
Bij eth0 staat het volgende:
Link encap: Ethernet Hwaddr 00:40:D0:3E:BD:0E
Inet6addr: fe80::240:d0ff:fe3e:bd0e/64 seope: link
UP broadcast/ MTU:1500 Metric: 1
RX packets:0 errors: 0 dropped: 0 overruns: 0 frame: 0
TX packets: 178 error: 0 dropped: 0 overruns: 0 carrr: 0 collisions: 0 txqueuelen: 1000
RX bytes: 0 (0.0 b) TX bytes: 59544 (58.1 KiB)
Interrupt:10 Base address:0xe300
Bij lo staat het volgende:
Link encap: local loopback
inet addr: 127.0.0.1 mask: 255.0.0.0
inet 6 addr: :: 1/128 scope: host
UP LOOPBACK RUNNING MTU 16436 metric:1
RX packets:70088 errors: 0 dropped: 0 overruns: 0 frame: 0
TX packets:70088 errors: 0 dropped: 0 overruns: 0 carrier: 0
collisions:0 txqueuelen:0
RX bytes: 5222065 (4.9 MiB) TX bytes 52222065 (4.9 MiB)
De tekst in /etc/network/interfaces:
#This files discribes the network interfaces available on your system
# and how to activate them for more information see interfaces(5).
#the loopback network interface
auto lo
iface lo inet loopback
#this is a list of hotpluggable network interfaces
#th4ey will ben activated automatically by the hotplug subsystem.
mapping hotplug
script grep
map eth0
iface eth0 inet dhcp
auto eth0
Voor de zekerheid heb ik nog wat meer opgezocht /etc/network/ifstate:
eth0=eth0
lo=lo
/etc/network/options:
ip-forward=no
spoofprotect=yes
syncookies=no
Hopelijk kunnen jullie hier meer uitlezen dan ik
Groetjes