@Dennisgroot
dat moet je in multisync plakken
Toepassingen->Hulpmiddelen->Multisync-gui
Dan toevoegen
Member toevoegen
Syncml over OBEX en nog een keer Evolution
Je plakt dat in Syncml-obex-client
Met plakken bedoel je toevoegen in multisync?
Dan moet ik toch ook nog de waarden in Syncml-obex-client invullen? Krijg in elk geval fout meldingen als ik het laat zoals het is.
Deze melding:
Error while initializing syncengine: Bluetooth selected but no bluetooth address given.
Dat moet dan hier ergens?:
<?xml version="1.0"?>
<config>
<!-- (Only for bluetooth) The bluetooth address if the bluetooth mode is selected -->
<bluetooth_address></bluetooth_address>
(dat vul ik hier dat 2x in? en natuurlijk hoe haal ik het adres uit de telefoon?
<!-- (Only for bluetooth) The bluetooth channel to use. `sdptool browse $MAC` to search for the correct channel -->
<bluetooth_channel></bluetooth_channel>
<!-- (Only for USB) The usb interface number of the SYNCML-SYNC target. use syncml-obex-client -u (you will need access to the USB raw device) to find it. -->
<interface>0</interface>
<!-- The string that the plugin will use to identify itself. Some devices need a special string here. -->
<identifier></identifier>
<!-- The syncml version to use: 0 for 1.0, 1 for 1.1 and 2 for 1.2 -->
<version>1</version>
<!-- if the plugin should use wbxml -->
<wbxml>1</wbxml>
<!-- The username to use. Leave empty to not require a username -->
<username></username>
<!-- the password for the username -->
<password></password>
<!-- sets the connection type to use. 5 means obex over usb, 2 means obex over bluetooth -->
<type>2</type>
<!-- If wbxml is enabled, defines wether the wbxml should use string tables -->
<usestringtable>0</usestringtable>
<!-- Never send ADD command, but send REPLACE (not needed normally) -->
<onlyreplace>0</onlyreplace>
<!-- Workaround around for mobile phones which only use local timestamps and _no_ UTC timestamps! -->
<onlyLocaltime>0</onlyLocaltime>
<!-- Sets the maximum allowed size in bytes of incoming messages (some device need this option set). Example: 10000 -->
<recvLimit>0</recvLimit>
<maxObjSize>0</maxObjSize>
<!-- The name of the contacts db. Must be the same as the phones sends -->
<contact_db>Contacts</contact_db>
<!-- The name of the calendar db. Must be the same as the phones sends -->
<calendar_db>Calendar</calendar_db>
<!-- The name of the note db. Must be the same as the phones sends -->
<note_db>Notes</note_db>
</config>
M.a.w. hoe ga ik bovenstaande regels af....