Helpt het ook niet om de # weg te halen het lijkt mij dat je de door jouw ingestelde tijd krijgt. interval =5sec dus met jouw instelling zou je dan een tijd van 254*5=1270 sec=21,16 minuten moeten krijgen.
echter man hdparm zegt hierover:
-S Set the standby (spindown) timeout for the drive. This value is
used by the drive to determine how long to wait (with no disk
activity) before turning off the spindle motor to save power.
Under such circumstances, the drive may take as long as 30 sec�
onds to respond to a subsequent disk access, though most drives
are much quicker. The encoding of the timeout value is somewhat
peculiar. A value of zero means "timeouts are disabled": the
device will not automatically enter standby mode. Values from 1
to 240 specify multiples of 5 seconds, yielding timeouts from 5
seconds to 20 minutes. Values from 241 to 251 specify from 1 to
11 units of 30 minutes, yielding timeouts from 30 minutes to 5.5
hours. A value of 252 signifies a timeout of 21 minutes. A
Dus als je hdparm de optie -S met de waarde zero geeft zou de spindown uitgeschakeld moeten zijn.
Ik zou zeggen probeer het uit. Dus hdparm -S 0 of het woord zero i.p.v de 0 moet je maar even kijken.
Met vriendelijke groet,
Gijs
Edit: De hoofdletter S gebruiken niet de kleine s die optie wordt afgeraden.