linux:~ # ifconfig
eth0 Link encap:Ethernet HWaddr 00:11:09:C3:CA:C0
inet addr:192.168.2.100 Bcast:192.168.2.255 Mask:255.255.255.0
inet6 addr: fe80::211:9ff:fec3:cac0/64 Scope:Link
UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500 Metric:1
RX packets:27 errors:0 dropped:0 overruns:0 frame:0
TX packets:40 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:4630 (4.5 Kb) TX bytes:3761 (3.6 Kb)
Interrupt:11 Base address:0xe600
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:62 errors:0 dropped:0 overruns:0 frame:0
TX packets:62 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:4012 (3.9 Kb) TX bytes:4012 (3.9 Kb)
linux:~ # route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.2.0 * 255.255.255.0 U 0 0 0 eth0
link-local * 255.255.0.0 U 0 0 0 eth0
loopback * 255.0.0.0 U 0 0 0 lo
default 192.168.2.1 0.0.0.0 UG 0 0 0 eth0
linux:~ # cat /etc/resolv.conf
### BEGIN INFO
#
# Modified_by: dhcpcd
# Backup: /etc/resolv.conf.saved.by.dhcpcd.eth0
# Process: dhcpcd
# Process_id: 4489
# Script: /sbin/modify_resolvconf
# Saveto:
# Info: This is a temporary resolv.conf created by service dhcpcd.
# The previous file has been saved and will be restored later.
#
# If you don't like your resolv.conf to be changed, you
# can set MODIFY_{RESOLV,NAMED}_CONF_DYNAMICALLY=no. This
# variables are placed in /etc/sysconfig/network/config.
#
# You can also configure service dhcpcd not to modify it.
#
# If you don't like dhcpcd to change your nameserver
# settings
# then either set DHCLIENT_MODIFY_RESOLV_CONF=no
# in /etc/sysconfig/network/dhcp, or
# set MODIFY_RESOLV_CONF_DYNAMICALLY=no in
# /etc/sysconfig/network/config or (manually) use dhcpcd
# with -R. If you only want to keep your searchlist, set
# DHCLIENT_KEEP_SEARCHLIST=yes in /etc/sysconfig/network/dhcp or
# (manually) use the -K option.
#
### END INFO
nameserver 192.168.2.1
linux:~ #