Ik probeer momenteel een draadloze verbinding tot stand te brengen met mijn Linksys WAG200G (firmwareversie 1.07) ADSL/Router. Mijn netwerkkaart (Linksys WMP54G, pci) wordt ondersteund door Ubuntu 6.10. Zowel met dhcp als handmatig ingesteld krijg ik geen verbinding. Ik heb WEP uitgeschakeld, maar dit had geen effect. Wireless Assistant vindt allerlei netwerken in de buurt (waaronder mijn eigen), echter verbinding maken lukt met geen van alle.
Voor de volledigheid een aantal gegevens:
ifconfig:
wlan0 Link encap:Ethernet HWaddr 00:16:B6:5D:84:04
inet addr:192.168.1.150 Mask:255.255.255.0
inet6 addr: fe80::216:b6ff:fe5d:8404/64 Scope:Link
UP RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:65 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:7632 (7.4 KiB)
Base address:0x4000
wmaster0 Link encap:UNSPEC HWaddr 00-16-B6-5D-84-04-00-00-00-00-00-00-00-00-00-00
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Base address:0x4000
iwconfig:
wmaster0 IEEE 802.11g Frequency:2.412 GHz
RTS thr:off Fragment thr=2346 B
wlan0 IEEE 802.11g ESSID:"kleene_linksys"
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
RTS thr:off Fragment thr=2346 B
Een selectie uit de terminal-informatie van "sudo wlassistant":
Selected interface: wlan0
ifconfig_status: /sbin/ifconfig wlan0
scan: /sbin/iwlist wlan0 scan
Networks found: 7
Checking for active connection.
Trying to get gateway address...
...from 'route'
Gateway address: 192.168.1.1
ACTION: CONNECT.
Checking for active connection.
Trying to get gateway address...
...from 'route'
Gateway address: 192.168.1.1
kill_dhcp: /sbin/dhclient -r wlan0
==>stderr: Internet Systems Consortium DHCP Client V3.0.4
Copyright 2004-2006 Internet Systems Consortium.
All rights reserved.
For info, please visit
http://www.isc.org/sw/dhcp/en:
wmaster0: unknown hardware address type 801
wmaster0: unknown hardware address type 801
Listening on LPF/wlan0/00:16:b6:5d:84:04
Sending on LPF/wlan0/00:16:b6:5d:84:04
Sending on Socket/fallback
ifup: /sbin/ifconfig wlan0 up
iwconfig_set: /sbin/iwconfig wlan0 mode managed channel 2.462 G key off essid kleene_linksys
==>stderr: Error for wireless request "Set Mode" (8B06) :
SET failed on device wlan0 ; Device or resource busy.
iwconfig_ap: /sbin/iwconfig wlan0 ap 00:14:BF:6E:1B:38
ifconfig_manual: /sbin/ifconfig wlan0 192.168.1.150 netmask 255.255.255.0
route: /sbin/route add default gw 192.168.1.1
Trying to get gateway address...
...from 'route'
Gateway address: 192.168.1.1
OggS-SEEK: at 0 want 60408 got 51136 (diff-requested 60408)
OggS-SEEK: at 60352 want 520 got 0 (diff-requested -59832)
Checking for active connection.
Trying to get gateway address...
...from 'route'
Gateway address: 192.168.1.1
ACTION: CONNECT.
ACTION: CONNECT.
Checking for active connection.
Trying to get gateway address...
...from 'route'
Gateway address: 192.168.1.1
kill_dhcp: /sbin/dhclient -r wlan0
==>stderr: There is already a pid file /var/run/dhclient.pid with pid 134993416
Internet Systems Consortium DHCP Client V3.0.4
Copyright 2004-2006 Internet Systems Consortium.
All rights reserved.
For info, please visit
http://www.isc.org/sw/dhcp/Ik heb overal op het web al gezocht naar oplossingen, maar niets concreets kunnen vinden. Ik hoop dat iemand me uit de brand kan helpen.
Bij voorbaat dank.
