Hoi,
Ik wil de 'Xine' installeren. Moet ik Xine-ui hebben of gxine... what is the differents? Of is er nog een andere betere dvd-player?
en nu staan er wel introducties voor instructie op de site, maar daar kan ik niet echt iets uit wijs worden. Kan iemand me bij den hand nemen?
Deze twee bestanden heb ik gedownloaded:
xine-lib-1.1.1.tar.gz
xine-ui-0.99.4.tar.gz
Instructions:
Download the latest xine-lib and gxine/xine-ui tarballs, then follow these instruction. To unpack a tarball, use:
tar xfvz tarballname.tar.gz
The following instructions will install xine in /usr/local where it will be visible for all users. You need root privileges to do this on most systems.
After unpacking xine-lib, issue:
./configure
make install
Make sure your /etc/ld.so.conf contains /usr/local/lib and continue with:
ldconfig
Now unpack your frontend (gxine or xine-ui or ...), then:
./configure
make install
Complete build instructions
The build process is the same for all of the xine modules.
You have to start with xine-lib. If built and installed successfully, you can continue with the frontend(s).
If you have installed xine-lib to a non-standard prefix, make sure that you have $prefix/bin in your PATH and that your linker finds libs in $prefix/lib - otherwise trying to build modules that rely on xine-lib will fail with configure complaining about not finding certain parts of libxine. Using bash you can do something like:
export PATH="$prefix/bin:$PATH"
export LD_LIBRARY_PATH="$prefix/lib:$LD_LIBRARY_PATH"
to make sure libxine can be found by the frontend(s).
Last but not least. Here the build instructions. As stated earlier, those are the same for every xine module.
./autogen.sh [-> *only* if you checked your sources out of CVS]
./configure
make
make install
Alvast bedankt.
